33
Zone Program Change
Each zone can send Zone Program Change messages when you activate it, ensuring that the
zone always uses the same program.
To set the zone program change:
1. Press and hold Zone for 1 second to enter Zone Edit Mode. The active Zone Buttons 1–4
will flash.
2. Press one of Zone Buttons 1–4 to edit that zone. Alternatively, you can press multiple
Zone Buttons 1–4 to edit those zones simultaneously.
3. Press and hold Shift, and then press the Prog key. The display will show PRO and the
program change number.
4. Enter the desired program change number by doing one of the following:
• While holding Shift, use the numeric keys (0–9) to enter a program change number
(000–127).
• Use the Preset Down/Up () buttons to select a program change number (000–127).
5. While holding Shift, press the Enter key. (This will also send the program change
message.)
6. To set the program change for another zone, repeat Steps 2–5.
To exit Zone Edit Mode, press Zone.
To Next Page
Loading...
Need help?
General
