78
Program Cycle
You can also set a pad to cycle through 3 or 4 program numbers by each time you press it.
To assign a pad to cycle through 3 or 4 program numbers:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired pad. The pad’s number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
pad’s number (P__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 156 (to increment
the program number) or 155 (to decrement the program number).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show the pad’s
number (P__) and the lowest program number it will send.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show the pad’s
number (P__) and the highest program number it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (
000–127).
9. Press and hold Shift, and then press the Data 3 / –/+ key. The display will show DATA+1
for 1 second and then show the pad’s number (P1–P16) an additional program number it
will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a program number
between the lowest and highest values (000–127).
11. Optional: To set one more program number the pad will send, repeat Steps 9–10 once
more.
12. Press the Enter key. The pad is now set to cycle through the assigned 3 or 4 program
numbers, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
