22
15
16
17 18 19
20
14
21
14. Transport Controls: These six buttons are dedicated buttons for sending conventional
Mackie Control/HUI transport control commands: Rewind (), Fast-Forward (), Stop
(), Play (), and Record ().
15. Display: Use this screen to view parameter values, settings, and messages relevant to
Code 61’s current operation. The various messages shown here are described throughout
this User Guide.
16. Preset Down/Up (): Use these buttons to move to the previous or next preset.
You can also use these buttons to cycle through the editable parameters shown in the
display, set the global MIDI channel, or set the MIDI channel of a zone of the keyboard.
17. Shift: Press and hold this button to access the secondary functions of certain buttons and
keys. Press this button in Zone Edit Mode to access additional zone editing functions.
18. Channel: Press this button to enter or exit Channel Mode. In Channel Mode, use the
Preset Down/Up () buttons to change Code 61’s global MIDI channel. See Operation
> Basic Concepts > Channels > Global Channel to learn more about this mode.
19. Edit: Press this button to enter or exit Edit Mode. In Edit Mode:
• Use the Preset Down/Up () buttons to change the value or setting of the
parameter shown in the display.
• Use the keyboard’s keys to access additional functions or commands (printed above
the keys).
Learn more about this mode in Operation > Basic Concepts > Edit Mode.
20. Zone, 1–
4: Press the Zone button to enter Zone Mode, which lets you use 4 different
overlapping or non-overlapping ranges of keys on different MIDI channels. This is useful
for sending notes to 4 virtual instruments 4 external synthesizers from the same keyboard,
for example.
Press any of the 1–4 buttons simultaneously or separately (when the Zone Button is
active/lit) to activate or deactivate those zones of the keyboard. When a zone is active, its
corresponding button will be lit.
Press and hold the Zone Button for 1 second to enter or exit Zone Edit Mode. You can
press any of the flashing 1–4 buttons to edit that zone.
Learn more about zones in Operation > Basic Concepts > Zones.
21. Transpose: Press and hold this button and press one of the Pad Octave –/+ or Key
Octave –/+ buttons to move the pads or keys (respectively) down or up a semitone.
Press and hold Shift and press this button to send a “MIDI Panic” message. This means
all MIDI notes will stop and all controls will stop sending their messages.
To Next Page
Loading...
Need help?
General
