Why is my MacDon Farm Equipment cutterbar pushing too much trash and dirt?
If your MacDon Farm Equipment's cutterbar is pushing too much trash and dirt, readjust the float to make the header lighter, decrease the header angle with lift cylinders, and shorten the center-link.
What to do if MacDon Farm Equipment is not picking up down crop?
If your MacDon Farm Equipment is not picking up down crop, try the following: Lower the cutterbar, increase the header angle, and lower the reel. Move the reel forward, reduce ground speed or increase reel speed. Increase finger pitch aggressiveness and install lifter guards.
What to do if MacDon Farm Equipment has heads shattering or breaking off?
If the heads are shattering or breaking off when using your MacDon Farm Equipment, try the following: Reduce the reel speed, raise the reel, and reduce the ground speed. Consider operating at night when humidity is higher.
What to do if MacDon Farm Equipment has excessive header vibration?
To address excessive header vibration in your MacDon Farm Equipment, adjust the hold-downs and knife timing. Check the engine speed of the windrower, replace the knife, and tighten or replace any loose parts. Straighten the cutterbar if necessary.
How to prevent MacDon Farm Equipment reel from wrapping on end?
To prevent wrapping on the reel end of your MacDon Farm Equipment, reduce the cam setting, raise the reel, and reduce the reel speed. Install optional endshields and center the reel in the header.
What to do if MacDon Farm Equipment reel carries over excessive amounts of plants or wads?
If your MacDon Farm Equipment reel carries over excessive amounts of plants or wads, increase the draper speed and increase finger aggressiveness (cam position).
What to do if MacDon Farm Equipment has cut grain falling ahead of cutterbar?
If cut grain is falling ahead of the cutterbar on your MacDon Farm Equipment, increase the ground speed and reel speed. Lower the reel and cutterbar, and move the reel back. If cutting at speeds over 10 km/h (6 mph) with a high torque (10-tooth) reel drive sprocket, replace it with a standard torque (19-tooth) reel drive sprocket. Replace knife components if needed.
How to fix MacDon Farm Equipment reel not releasing material in normal standing crop?
If the reel is not releasing material in normal standing crop with your MacDon Farm Equipment, reduce the reel speed, raise the reel, reduce the cam setting, and move the reel forward.
How to solve insufficient draper speed on MacDon Farm Equipment?
To address insufficient draper speed on your MacDon Farm Equipment, increase the control setting if the speed control is set too low. Also, increase the relief pressure to the recommended setting, adjust to the correct speed for the windrower model, replace the gear pump if necessary, and adjust to increase the setting.
What to do if MacDon Farm Equipment has bent or broken guards?
General| Brand | MacDon |
|---|---|
| Model | D65 |
| Category | Farm Equipment |
| Language | English |
To Next Page
