MacDon D65 - 3.7.11 Reel Fore-Aft Position

214328 73 Revision A
5.12 Leveling Header
The windrower linkages are factory-set to provide the proper level for the header and should not normally
require adjustment.
1. If header is not level, check pressure of windrower’s tires to ensure they are properly inflated (refer to your
windrower’s operator’s manual).
2. If header is still not level, adjust windrower linkages as required (refer to appropriate section in windrower’s
operator’s manual).
NOTE:
The float springs are NOT used to level the header.
PERFORMING PREDELIVERY CHECKS