Mahr GmbH, MarSurf M 300 and RD 18
41
2. If the results are to be saved with the file
name displayed at upper right:
Activate the "Save results" button •
again.
If the results are to be saved with an existing
file name:
In the "Selection" area, activate the but-•
ton for the file that is to be overwrit-
ten.
The file name will be displayed at up-
per right.
Activate the "Save results" button •
again.
In this case, the results and the
file header will be attached to
the current file.
If the results are to be saved with user-de-
termined file name:
Press the • 6 key next to the input box at
upper right.
Enter the desired file name (max. •
8 characters plus the file extension
".S2R"), press START and activate the
"Save results" button again.
3. The folder and file name are displayed
for the duration of the save procedure, e. g.
"a:\RESULT\R000_001.S2R".
To open the "Results" menu:
1. Use the MENU key to select the main
menu.
2. Open the "USB memory" menu by pressing
the key, then open the "Results" menu.
Some of the functions of the "USB mem-
ory / Results" menu can only be accessed
after entering the code number.
27
Results files are saved in the "RESULT" folder
with the following structure:
R000_123.S2R
File extension (.S2R)
Number of results file (001 to
999), can be modified
Identifier for results files, can
be modified
Saving results manually
Enter the desired settings before be-
ginning a series of meas urements (see
Section 3.5).
To save the results for the selected parameters
as well as the date and time of the most recent
meas urement:
1. In the "Results" menu activate the "Save re-
sults" button by pressing the key.
The file name will be displayed at upper
right with the lowest available results file
number.
27 If the code number "00000" set at the factory is used, the
"USB memory / Results" menu is freely accessible.
To Next Page
Loading...
Need help?
General
