Mahr GmbH, MarSurf M 300 and RD 18
52
Right-click on the desired removable •
medium ( ) in the right window
and select "Change drive letter and
paths…".
Click on • Add….
Select the option "Assign the following •
drive letter", then select an available
drive letter that will never be used for
a network drive.
Confirm twice with • OK and close Com-
puter Management.
4. Copy or cut the required profiles from the
"PROFILE" folder and the required results
files from the "RESULT" folder.
To prevent possible data loss, the
MarSurf M 300 must be removed
from the computer using the "Safely
remove hardware" function.
5. Click the "Safely remove hardware" icon
in the bottom right-hand corner of the
Windows taskbar’s information area.
6. Select e. g. "Safely remove USB Mass
Storage Device – Drive (E:)".
7. Wait until the "Safe to remove hardware"
message appears and disconnect the instru-
ment from the USB interface.
8 Interfaces
Connecting the MarSurf M 300 8.1
to a Computer (USB Interface)
The MarSurf M 300's USB interface allows it to
be connected directly to a computer. It is auto-
matically recognized as a USB memory stick by
Windows 2000 and above.
This allows meas uring results and profiles to be
transferred to the computer for evaluation, e. g.
with the evaluation software MarSurf XR 20 or
XP 20.
The "MarSurf PS1 / M 300 Explorer" software
(see Section 10) enables records of the profiles
and meas uring results to be saved and printed.
To connect the MarSurf M 300 to a computer:
1. Switch on the MarSurf M 300 with the
green START key.
2. Connect the USB cable (3018921) to the in-
terface
(11) of the MarSurf M 300 with
the mini-USB plug and to the computer
with the normal USB plug.
Steps 3 and 4 are not required when using "Mar-
Surf PS1 / M 300 Explorer" software.
3. In Windows Explorer, switch to the new
"MarSurfM300" drive.
If the computer using Windows XP did not
assign MarSurf M 300 a drive:
In Windows Explorer, right-click on "My •
computer" and select "Manage" in the
menu that appears.
Click on "Disk management" in the left •
window of Computer Management.
To Next Page
Loading...
Need help?
General
