Man B&W L35MC6-TII - Space Requirement for the Engine

MAN B&W 5.02
Page 2 of 2
MAN Diesel
MAN B&W L35MC6 198 57 87-0.0
Cyl. No. 5 6 7 8 9 10 11 12
A
min. 4,74 4,774 5,374 5,974 6,574
Available on request
Fore end: A minimum shows basic engine
A maximum shows engine with
built-on tuning wheel
For PTO: See corresponding space
requirement
max. 4,423 5,023 5,623 6,223 6,823
B 2,00
MAN Diesel TCR
The required space to the
engine room casing includes
top bracing
ABB TPL
Mitsubishi MET
C
2,638 2,738 2,888 3,038 3,038 MAN Diesel TCR
Dimension according to tur-
bocharger choice at nominal
MCR
2,377 2,578 2,728 2,878 2,878 ABB TPL
2,343 2,525 2,675 2,825 2,825 Mitsubishi MET
D ,923 ,963 2,003 2,038 2,073
The dimension includes a cofferdam of 600 mm
and must full minimum height to tank top ac-
cording to classication rules
E
5,25
(same height for electrical and man-
ual crane)
The minimum distance from crankshaft centre
line to lower edge of deck beam, when using
MAN B&W Double Jib Crane
F
5,400
Minimum overhaul height, normal lifting
procedure
5,350
Minimum overhaul height, reduced height lifting
procedure
G ,900
See ‘Engine Top Bracing’, if top bracing tted
on camshaft side
H
4,67 4,67 4,67 4,67 4,67
MAN Diesel TCR
Dimension according to tur-
bocharger choice at nominal
MCR
- - - - - ABB TPL
3,860 3,860 3,860 3,860 3,860 Mitsubishi MET
I
,340 ,340 ,340 ,340 ,340
MAN Diesel TCR
Dimension according to tur-
bocharger choice at nominal
MCR
- - - - - ABB TPL
,070 ,070 ,070 ,80 ,80
Mitsubishi MET
J 360
Space for tightening control of holding down
bolts
K See text
K must be equal to or larger than the propeller
shaft, if the propeller shaft is to be drawn into
the engine room
L 2,920 2,920 3,380 3,380 3,380 Space for air cooler element overhaul
M 2,230 2,230 2,920 2,920 2,290 Space for water mist catcher overhaul
N ,26
The distances cover required space and
hook travelling width for turbocharger TCR22
O ,466
R 782
S 84
V 0°, 5°, 30°, 45°, 60°, 75°, 90°
Maximum 5° when engine room has minimum
headroom above the turbocharger
Fig. 5.02.01b: Space requirement for the engine