9
10
11
12
Removing and installing, repairing oil pump
57
Fig. 9
Fit on the cover.
Tighten the mounting bolts with the prescribed
torque.
Grind or exchange heavily worn covers.
Checking the axial clearance of the
pump wheels
Fig. 10
Position dial gauge and push shaft up to the stop
in one direction and set dial gauge to ”0”.
Push the shaft in the opposite direction and read
off the needle deflection on the dial gauge.
Installing oil pump
Fig. 11
Tighten the mounting bolts with the prescribed
torque.
D Before installing, check whether the oil pump
run smoothly and then fit it / them free of ten-
sion
D Fit oil suction line À with seal in a tension−free
manner
D Screw on pressure−relief valve Á without seal
Before fitting the oil pan, run the engine to check
that the crankshaft drive and oil pumps are running
smoothly and easily.
Attaching oil pan
Fig. 12
Fit an oil pan seal.
Fit oil pan to crankcase and screw in the mounting
bolts.
Tighten the mounting bolts with the prescribed
torque.
1
2
To Next Page
Loading...