EasyManuals Logo

Man D 2842 LE 620 User Manual

Man D 2842 LE 620
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
13
14
15
Removing and installing, repairing oil pump
58
Filling with engine oil
Caution:
Do not add so much engine oil that the oil
level rises above the max. marking on the
dipstick. Overfilling will result in damage
to the engine.
Fig. 13 and Fig. 15
Refill with fresh engine oil at the oil filler neck À.
After filling with oil disconnect electric connection
from speed pickup. Turn engine over with starter
until oil pressure warning lamp goes out / oil pres-
sure gauge indicates pressure. Then restore elec-
tric connection to speed pickup. Then start the en-
gine and allow it to run at medium speed for a few
minutes. Check oil pressure and leaks.
Then shut down the engine. After about 20 min-
utes, check the oil level.
D Pull out dipstick
D wipe it with a clean, lintfree cloth
D and push it in again up to the stop
D Pull out dipstick again
The oil level should be between the two notches in
the dipstick and must never fall below the lower
notch. Top up oil as necessary. Do not overfill.
1
1
1
Oil
?
MIN
MAX

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Man D 2842 LE 620 and is the answer not in the manual?

Man D 2842 LE 620 Specifications

General IconGeneral
BrandMan
ModelD 2842 LE 620
CategoryEngine
LanguageEnglish

Related product manuals