Manitou MAN'GO 12 - 250 Hour Checks - Filters and Brakes; Fuel Filter Cleaning and Belt Tension; Platform Stickers and Overload Check

C12 – FUEL FILTER
CLEAN
- Set the lifting platform on a horizontal surface, with the engine switched off.
- Open the turret's left cover.
- Close the fuel tap 1 to the OFF position (B).
- Carefully clean the exterior of the filter and its holder to prevent dust from entering
the system.
- Unscrew the retaining ring 2, remove the container 3 and clean the interior with a
paintbrush impregnated with clean diesel.
- Remove the filter cartridge 4 and plunge it in diesel to rinse it.
- Refit the assembly.
- Open the fuel tap 1 to the ON position. (A).
- Bleed the fuel supply circuit (see: 3 - MAINTENANCE: G1 – FUEL SUPPLY CIRCUIT).
C13 – ALTERNATOR/FAN/CRANKSHAFT BELT TENSION
CHECK / ADJUST
(see: 3 - MAINTENANCE: B4).
C14 – PLATFORM STICKERS
CHECK
Check that the safety stickers are present (see: 1 – SAFETY STICKERS).
C15 – OVERLOAD
CHECK
The overload must activate at between 1.1 and 1.2 times the nominal load (see CHAPTER 2 - General characteristics).
Expected result:
• Nominal load 230 Kg : Activation load between 253 kg and 276 kg.
The overload sensors must activate at the same time.
Refer to the repair manual for information about adjusting the overload
t
IMPORTANT
t
In the case of malfunction, forbid usage of the nacelle. Consult your dealership.
3 - 22
ON
ON
OFF
A
B
2
3
4
1
647533 (09/10/2015) MAN'GO 12