SETTING DOWN A HIGH-LEVEL LOAD
- Bring the load up to the front of the stack in the transport position (1).
- Put the parking brake on and set the forward/reverse selector to neutral.
- Lower the stabilisers to the ground (2).
- Carefully raise the mast (3) until the load is higher than the top of the stack.
- Carefully extend the extender (4).
- Carefully place the load in a horizontal position by tilting the mast forwards (5) and
set it down gently on the stack (6), while checking the correct positioning of the load.
- Carefully retract the extender (7) to free the forks.
- Lower the forks (8) and place them in the transport position.
- Retract the stabilisers (9).
- Release the parking brake then move the lift truck as required.
1-16
7
5
6
1
2
4
3
9
8
647737 M1 (A102020)
TMM ... ST5 S1
To Next Page
Loading...
