Manitou TMM 20 K ST5 S1 - Page 90

CLEAN Fuel tank
Place the lift truck on level ground with the engine stopped.

IMPORTANT

While carrying out these operations, do not smoke or work near a flame.
Never attempt to carry out welding or any other operation by yourself,
as this could cause an explosion or a fire.
- Open the engine cover.
- Inspect the parts of the fuel circuit and the tank liable to leak, both visually and
by touch.
- In the event of a leak, contact your dealer.
- Place a container under drain plug1 and unscrew the plug.
- Remove the filler plug 2 to ensure that the oil is drained properly.
- Rinse with ten litres of clean diesel through the filler port.
- Refit and tighten the drain plug 1.
- Fill the fuel tank with clean diesel filtered through the filler port 3.
- Refit the filler plug.
- If necessary, bleed the fuel supply circuit (
FUEL SUPPLY CIRCUIT).
REPLACE Safety dry air filter cartridge
- To remove and refit the cartridge AIR FILTER CARTRIDGE.
- Carefully remove the dry air filter safety cartridge 1 to reduce dust fall as much as
possible.
- Clean the gasket surface on the filter with a damp, clean lint-free cloth.
- Before fitting, check the condition of the new safety cartridge (FILTER CARTRIDGES
AND BELTS).
- Introduce the cartridge into the filter axis and push it in, pressing the edges and
not the middle.
NB: The safety cartridge replacement frequency is given for information only. The
safety cartridge must be changed for every two changes of the air filter cartridge.
Âo
1,000 H - ROUTINE SERVICING - EVERY 1,000HOURS OF SERVICE OR 2 YEARS
ALSO PERFORM THE500 HOUR ROUTINE SERVICING OPERATIONS.
3 - 26
1
3
2
1
647737 M1 (A102020) TMM ... ST5 S1