Marantz PM-14S1 - Operational Settings

19
Preparation Connections Playback Tips Appendix
ENGLISH
Settings
Switching the illumination lamp
setting
Theilluminationlampsonthebothsidesoftheunitmainpanel
canbeturnedonoro.
•The illumination lamp is set to on in the factory default
settings.
Turning the illumination lamp o
Press and hold DISPLAY on the unit for 2 seconds
or longer.
Theilluminationlampsturno.
Turning the illumination lamp on
Press and hold DISPLAY on the unit for 2 seconds
or longer.
Theilluminationlampslight.
Setting the Auto Standby mode
Youcansettheunittoautomaticallyswitchtostandbymode
if the unit is not operated for 30 minutes when there is no
audioinput.
AutoStandbymodeissettoonbydefault.
Turning Auto Standby mode o
Press and hold TONE on this unit for 5 seconds or
longer.
“AUTOSTBYOFF”appearsonthedisplay.
Turning Auto Standby mode on
Press and hold TONE on this unit for 5 seconds or
longer.
“AUTOSTBYON”appearsonthedisplay.
•Thisunitwillautomaticallyenterstandbymodeafterabout
continuous30minutesinthefollowingconditions.
•Nooperationperformedontheremotecontrol.
•Nooperationofthisunit.
•Thedisplaywillshowtheremainingtimeforthreeminutes
beforetheunitsentersstandbymode.
•InF.C.B.S. connection, onlythe ID 1masterunit activates
AutoStandbymode.IftheID1masterunitisoperatedwith
noaudioinput,settheAutoStandbymodetoo.
1.PM14S1N_ENG_Final_0708.indd 19 2013/07/11 19:14:19