Marantz SR9600 - Product Reset Procedure

12
12. Press ENTER button, The segments of the odd number
lines of horizontal in the FL light on.
13. Press ENTER button, The segments of the even number
lines of horizontal in the FL light on.
14. Press ENTER button, All the FL segments turns off.
15. Press ENTER button, Every time ENTER button is
pressed, DSP code is indicated in turn from NO.1 to
NO.28.
DSP CODE 01 03090103
No. Dev. SIG TYP Ver.
No. : DISP CODE ID Dev. : Device ID
SIG. : CODE SIG ID TYP. : CODE TYPE ID
Ver. : Version
16. Turn off the power to quit Service Mode.(Disconnect
mains cord from SR9600)
Note: When the unit is once turned into Service Mode, the
unit keeps this mode until the main power is turned
off. (Turning into stand-by mode does not make it quit
from Service Mode.) When the unit quits from Service
Mode, Information in the memory is also cleared and
the unit returns to the status when it is out from the
factory.
Product Reset
To reset the back up memory of the unit into the default
status,
follow the procedure below.
1. Turn on the unit and press MRAC and PURE DIRECT
button simultaneously more than 3 seconds.
2. After "DEFAULT" is displayed on FLD, then "CLEAR
MEMORY" is displayed on FLD, EEPROM is cleared to
the default status, µ-Pro. is reset and the unit returns to
the normal status. (Software Serial Number will not be
cleared.)
Note: When the unit is shipped from the factory, the
procedure above must be done to set the unit to initial
status.
13. ENTER
ȜǿȳǛƠLJƢŵ
FL
Ʒ್ૠᘍƕໜ໊ƠLJƢŵ
14. ENTER
ȜǿȳǛƠLJƢŵ
FL
ƕμෞ໊ƠLJƢŵ
15. ENTER
ȜǿȳǛƠLJƢŵ
ENTER
ȜǿȳǛƢࡇƴ
DSP Code ID
ƕ
NO.1
Ɣǒ
NO.28
LJư᪯ƴᘙᅆƞǕLJƢŵ
DSP CODE 01 03090103
No. Dev. SIG TYP Ver.
No. : DISP CODE ID Dev. : Device ID
SIG. : CODE SIG ID TYP. : CODE TYPE ID
Ver. : Version
16.
ᩓเǛЏǓLJƢŵᲢᩓเdzȸȉǛǻȃȈƔǒٳƠLJƢŵᲣǵ ȸ
ȓǹȢȸȉƸᚐᨊƞǕLJƢŵ