Marantz SR9600 - [B] Update Main and Sub Microprocessor Procedure

30
NECESSARY EQUIPMENT
• Windows PC (With Serial Port)
• RS-232C Cable straight type (9 Pin female - 9 Pin female)
• Update Tool (FDT)
• Update data :
(00M11AJ499Bxx.mot: For MAIN u-P)
(00M11AJ499Fxx.mot: For SUB u-P)
NOTE: xx is a revision number.
CABLE CONNECTION
Disconnect the mains cable from the Unit.
Connect RS-232C on the rear panel of the Unit and Serial
Port of windows PC with RS-232C cable.
WRITING MODE (MAIN ONLY)
Insert a thin rod to the hole near the MULTI RC terminal and
push the switch inside to turn on the switch.
Connect the mains cable into the Unit.
The Unit’s STANDBY (green) indicators turn on lights.
[B] UPDATE MAIN AND SUB MICROPROCESSOR PROCEDURE
[MAIN AND SUB MICROPROCESSOR Ʒ୿ƖƑ૾ඥ ]
࣏ᙲೞ֥
࣏ᙲೞ֥
•
Windows PC (Serial Port ˄Ɩ )
• RS-232C ǹȈȬȸȈDZȸȖȫ (9Pin ȡǹÛ9Pin ȡǹ )
• ୿ƖᡂLjဇǢȗȪDZȸǷȧȳȄȸȫ (FDT)
• ୿ƖᡂLjဇȇȸǿ
(00M11AJ499Bxx.mot: MAIN ȞǤdzȳဇ )
(00M11AJ499Fxx.mot: SUB ȞǤdzȳဇ )
NOTE: xx Ƹો༿ဪӭưƢŵ
DZȸȖȫዓ
DZȸȖȫዓ
ᩓเDZȸȖȫǛஜೞƔǒٳƠLJƢŵ
Windows PC Ʒ Serial Port ƱஜೞƷ RS-232C Port Ǜ
RS-232C DZȸȖȫưዓƠLJƢŵ
୿ƖᡂLjȢȸȉ
୿ƖᡂLjȢȸȉ
(MAIN
ȞǤdzȳƷLj
ȞǤdzȳƷLj )
ኬƍొǛƍஜೞƷ MULTI RC ᇢ܇ƷӫƱƳǓƴƋǔᆭƔǒǹ
ǤȃȁǛƠƯ୿ƖᡂLjȢȸȉƴλǓLJƢŵ
ஜೞƴᩓเDZȸȖȫǛࠀƠᡂLjLJƢŵ
ஜೞƷ
STANDBY( ዯ ) ƕໜ໊ƠLJƢŵ