Instruction Manual
12
– Instruction Manual
1.2.4.3 Training
THE FINAL MACHINE DOCUMENTATION MUST BE READ
The training of the operators assigned to the normal operation must follow the instructions set out
in the documentation of the final machine that the
P1 is fitted in, as this documentation cannot be
exhaustive.
The following categories of people require training:
1. operators assigned to transport, store and install the gauge, in order to:
• In order to ensure they are aware of the appropriate lifting and transport methods used for the parts
of the arm, as stipulated by Marposs, in order to prevent the risks associated with moving loads;
• Ensure they are aware of the correct storage procedures for the parts of the P1 in order to prevent
damaging important parts, not only in terms of safety but also from an operational point of view;
• Ensure they are aware of the correct P1 installation procedures, such as wiring the electrical parts, in
order to prevent assembly errors that could generate dangerous situations for the health and safety
of the operators.
2. operators assigned to supervise the normal operation of the P1, in order to:
• Ensure they adhere to the applicable regulations governing the use of the product, and that they
read and following the instructions and other information provided in the attached documentation.
3. operators assigned to the maintenance of the P1, in order to:
• Ensure they are aware of the correct procedures for carrying out scheduled and unscheduled
maintenances activities on the P1.
1.2.4.4 Procedures
Before performing any operation with the P1 described in these instructions, the Operator must check that all
safety conditions are met in order to prevent accidents.
In order to avoid hazardous situations, the operator must read section 2 “SAFETIES” of this document
carefully.
To Next Page
Loading...