marposs P1 - Typical Measurement Cyclogram

43 pages

Save Page as PDF

To Next Page

To Previous Page

Instruction Manual

– Instruction Manual

7.6

Cyclogram

The following is a typical cyclogram for P1 with In-Process measurements The cyclograms may vary,

depending on the application, consult the documentation supplied with the unit.

Main Page

Table of Contents3
General Information5
Foreward5
Original Version5
Warning for User5
Testing and Warranty6
Requesting Technical Support and Maintenance6
Instructions for Ordering Spare Parts6
Consultation Method7
Key to Symbols7
Targhette D'identificazione8
Safeties9
General Safety Information9
Reference European Community Directives9
Product Conformity9
Selecting the Operator9
Personal Protection Equipment (PPE)10
General Information11
P1 Safety Information13
Authorised and Unauthorised Use13
Risks, Protection, Warnings and Cautions13
Shipping and Storage14
General Warnings14
Personal Protection Equipment (PPE)14
Training14
State of the Work Equipment14
Moving Loads14
Receiving the Material14
Packing, Movement, Transport15
Packing15
Moving the Package15
Transporting the Package15
Disposing of the Packing Material15
Storage15
Storing the P115
Installation16
General Information16
Environmental Conditions16
Removing the P1 from Its Packaging17
P1 General Equipment Description18
Equipment Configurations18
Front Panel Description19
Connector Description20
General Technical Specifications21
Installation Procedure22
Installation of Electronical Unit22
Fastening the Electronic Unit23
Securing the Unit to the Machine Tool23
Panel Mounting24
Fastening with Support Bracket26
Connections of Electronic Unit27
Connection to Supply Voltage27
Functional Earth Connection27
I/Oconnection to Machine Logic Unit28
Installation of Measuring Head and Accessories31
Definition of Mechanical Parts31
Connections31
Measuring Head31
Carriage31
Positioning of Measuring Head in Machine32
Vertical Adjustment32
Horizontal Adjustment32
Zeroing33
Zeroing Procedure33
Zero Presetting33
Mechanical Zero-Setting of Measuring Head33
Azzeramento Rapido con Leva DI Bloccaggio35
Cyclogram36
Use of Electronic Unit37
Front Panel37
Setting the Controls Trigger Point39
SETTING the DELAY TIME (Τ)39
Setting the Zero Correction Value (Adj)39
Diagnostics and Maintenance40
Diagnostic at Switching on40
Routine Maintenance41
Cleaning the Machine41
Cleaning the Heads41
Extraordinary Maintenance41

marposs P1 - Typical Measurement Cyclogram

Table of Contents