marposs P1 - SAFETIES; General Safety Directives and Conformity; Operator Roles and Responsibilities

Instruction Manual
P1
Instruction Manual
9
2 SAFETIES
1.2 General safety information
1.2.1 Reference European Community Directives
The P1 has been designed and manufactured in accordance with the directives indicated on page 2.
The P1must be managed by a grinder type machine used to machine mechanical parts, in compliance with
the applicable safety standards in the user’s country in terms of machinery equipment
1.2.2 Product conformity
The P1 described in this document has been designed and manufactured to be installed in an industrial
plant.
WARNING
Any modification that alters the P1
design and/or manufacturing specifications may only be
implemented by Marposs, who shall be responsible for certifying compliance with the safety
standards.
Therefore the modifications or maintenance interventions not set out in this document shall be
considered unauthorised.
Marposs declines all responsibility in case of any non-compliance with the above.
1.2.3 Selecting the operator
1.2.3.1 Definition of the operator
The R.E.S.S. 1.1.1 “Definitions” of attachment I of machinery directive 2006/42/EC, defines the operator as
the person or persons assigned to install, operate, adjust, clean, repair and move a machine or to repair it.
1.2.3.2 State of health of the operator/installer
The operator assigned to install the P1 must be aware and responsible of the dangers that may be
generated during the installation of machining equipment.