Instruction Manual
Instruction Manual
5
1
GENERAL INFORMATION
1.1
Foreward
The P1 is designed and constructed to be installed in machines such as grinders as a machining control
accessory.
The P1 must be installed in accordance with the instructions provided in this manual and shall not conform to
the European standards and directives listed on page 2 unless these conditions are fulfilled.
Any modification that alters the P1 construction specifications, whether mechanical or electrical, can only be
performed by Marposs that will certify the compliance with the safety standards. Any modification or
maintenance not indicated in this document shall be considered unauthorised.
Marposs declines all responsibility in case of any non-compliance with the above.
The descriptions and illustrations attached to this document are not binding. Marposs reserves the right to
modify the product as and when necessary, in order to improve performance, or for any other reason, and
without the obligation to update this document.
This document may not be reproduced or transmitted, either wholly or partially, in any form or medium
without Marposs’ permission.
Legal action will be taken against any transgressors.
1.2
Original Version
This document was originally written in Italian.
In case of any dispute arising from translation errors and inaccuracies, even where carried out by Marposs,
the definitive version shall be in Italian.
1.3
Warning for User
This instruction manual provides all the specific information necessary for the knowledge and correct use of
the Marposs equipment in your possession.
THE PURCHASER MUST ABSOLUTELY INFORM THE PERSONNEL IN CHARGE OF THE EQUIPMENT
INSTALLATION, USE AND MAINTENANCE ABOUT THE CONTENT OF THIS MANUAL
The description given in this manual is addressed to the following categories of persons:
• Marposs personnel or personnel of the manufacturer of the machine tool that will house the P1
(henceforth the client) who will install the equipment directly.
• Technical personnel of the final user (henceforth the user) that will operate directly with the Marposs
equipment.
• User’s technical Personnel responsible for the maintenance of the production line in which the P1 is
installed.
This manual is an integrant part of the equipment so the user must keep it in good state and available for the
whole life of the equipment.
Marposs’ responsibility is limited to the correct use of the P1, as defined in this manual and its attachments.
Marposs shall give this manual and its attachments to the customer.
To Next Page
Loading...