marposs P1 - Page 2

Instruction Manual
2
P1
– Instruction Manual
This product conforms to EMC and SAFETY requirements as defined in directives
• 2014/35/EU issued 26/02/2014 (LOW VOLTAGE directive)
• 2014/30/EU issued 26/02/2014 (EMC directive)
This product has been designed, assembled and tested in conformity with the following European
standards:
• EN61010 - 1: (SAFETY)
• EN61326 - 1: (EMC)
The product conforms to the directive provided the installation conditions described in this manual are
respected.
This product is intended to operate in industrial locations; it is not intended for connections to a
public mains network but is intended to be connected to a power network supplied from a high or
medium voltage transformer.
About the Directive 2002/95/EC “RoHS” regulating the presence of certain hazardous substances in
Marposs electrical and electronic equipment, refer to
http://www.marposs.com/compliance_detail.php/eng/rohs
MANUFACTURER
MARPOSS S.p.A.
ADDRESS
Via Saliceto, 13 - Bentivoglio (BO) Italia
www.marposs.com
TYPE OF EQUIPMENT - MODEL
P1
MANUAL CODE
D2950000UC
ORIGINAL LANGUAGE OF THESE
INSTRUCTIONS
11/2014
ISSUE
11/2014
Translation of original document.
MARPOSS S.p.A. does not take on the obligation of notifying possible further changes to the product.
The descriptions reported in this book do not authorize any tampering by non-authorized personnel.
The warranty on the equipments will decay if such tampering is found.
© Copyright MARPOSS S.p.A. 2015