2-6 Masterflex SS B/T Washdown Digital Pump Drive with Advanced Connectivity
Section 2: Basic Setup & Settings
Masterflex
displayed.
5. Tap CONFIRM
.
Device Information
e Device Information Screen provides pump drive details such as MAC address, IP address, software
version, build date, and rmware version. Factory reset and updates are also accessed from the Device
Information Screen.
To access the Device Information Screen:
1. Tap SETTINGS
from any of the mode screens. e Settings Screen will be displayed.
2. SCROLL
through the Settings Screen pages to locate DEVICE INFORMATION.
3. Tap DEVICE INFORMATION. e Device Information Screen will be displayed.
See also "
Firmware Updates" on page 5-1, and "Restore Factory Settings" on page 5-1.
Screen Saver
e B/T has a screen saver to help extend the display life of the touchscreen. After 30 minutes of inactivity
the B/T will enter sleep mode and the display will turn o . Tapping the touchscreen will reactivate the drive.
To enable or disable the screen saver:
1. Tap SETTINGS
from any of the mode screens. e Settings Screen will be displayed.
2. SCROLL
through the Settings Screen pages to locate SCREEN SAVER.
3. Tap the SCREEN SAVER toggle to select either ON or OFF.
Device Name
Individual names can be assigned to each B/T Digital Pump Drive to make identi cation easier when using
more than one pump.
To assign a pump drive name:
1. Tap SETTINGS
from any of the mode screens. e Settings Screen will be displayed.
2. SCROLL
through the Settings Screen pages to locate DEVICE NAME.
3. Tap DEVICE NAME. e Device Name Screen will be displayed.
4. Enter the desired pump name using the onscreen keypad (up to 8 characters).
5. Tap CONFIRM
to save or CANCEL to discard changes.
To Next Page
Loading...
