Name: Matrix SETU VFXTH
Brand: Matrix
Rating: 5 (1 reviews)

To Next Page

To Previous Page

119 Matrix SETU VFXTH System Manual

Message Wait Indication (MWI)

Message Wait Indication parameters are applicable only when SIP Trunk is configured as Proxy or

Gateway.

• If you have subscribed for Message Wait Indication on the SIP Trunk for the voicemail service from your

ITSP, click MWI and configure the following parameters:

• Select the Subscribe for MWI check box. Default: Disabled.

•In Message Retrieval Number, enter the number provided to you by your ITSP. This number is used

for retrieval of voicemail on the SIP Trunk. The Message Retrieval Number may consist of a maximum

of 24 characters. 0-9, * and # are allowed. Default: Blank.

•In Send Message Notification on, select the FXS Port on which Message Wait Indication is to be sent

whenever there is a new message on the SIP Trunk. Default: FXS Port 1.

• If you have completed the configuration of SIP Trunk 1, click Submit to save settings.

• To configure the next SIP Trunk click the SIP Trunk number tab and follow the same instructions as given

earlier.

Copy Port Settings

• You can also copy the settings of a SIP Trunk to another SIP Trunk using the Copy button. To do this,

• Click the Copy button. The Copy SIP Trunk Parameters window opens.

• In the Copy SIP Trunk box, select the number of the port you want to copy settings From. In the to SIP

Trunk box, select the number of the port you want to copy the settings To.

• Click OK and close the window.

• Once you have copied the settings, you can again edit the specific parameters of the SIP Trunk you

copied the settings to.

Other manuals for Matrix SETU VFXTH

Questions and Answers:

Need help?

Do you have a question about the Matrix SETU VFXTH and is the answer not in the manual?

General