Matrix SETU VFXTH System Manual

177 Matrix SETU VFXTH System Manual
Emergency Number Dialing
SETU VFXTH supports the dialing of Emergency Numbers from all ports. Emergency numbers and their respective
Routing Groups (through which they are to be routed) must be configured in the Emergency Number Table.
When you select “Region”, the system loads the Emergency Numbers prevalent in the country you selected, in the
Emergency Number Table.
For each of these numbers loaded, the system assigns a default Routing Group to route the number. You may
reassign the Routing Group as appropriate.
You may also add more numbers of emergency services as per your requirement and assign Routing Group for the
numbers in this table.
The Emergency Number Table stores up to 10 numbers, including those loaded by default.
• For a few Regions, the system may not load the default Emergency numbers in the Emergency Table.
You may add the numbers as per your requirement.
• Emergency number Dialing will not work if Mains power to SETU VFXTH fails.
• Emergency Numbers have priority over Destination Number Table, PIN Number and Access Codes.
• The system does not apply End-of-Dialing when dialing Emergency Numbers.
• The system does not check Allowed-Denied Logic and Automatic Number Translation table when
dialing an Emergency Number.
SETU VFXTH will dial out an emergency number only if the FXO Ports/SIP Trunks included in the Routing Group
for the number are enabled.
Emergency Number can be dialed even when the option Block all calls through this FXS Port is enabled on the
FXS Ports.
Configuring Emergency Numbers
To configure the Emergency Number Table,
• Log into Jeeves.
• Click the Advanced Settings link.

Matrix SETU VFXTH Specifications

General

Brand	Matrix
Model	SETU VFXTH
Category	Gateway
Language	English