Matrix SETU VFXTH System Manual 10
• Unplug the system from the power outlet before cleaning. Do not use liquid cleaners, use only a dry and
soft cloth.
• Do not turn on the power supply until the installation is complete.
• Never open SETU VFXTH in power ON condition.
• Operate the system within the recommended power supply voltage range.
• Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
• Take the system to a qualified service person for repair work.
• Unplug the system from the power outlet and contact the qualified service personnel under the following
conditions:
• If liquid has been spilled onto it.
• If it has been exposed to rain or water.
• If it has been dropped or the cabinet has been damaged.
• If it does not operate normally.
Battery
SETU VFXTH contains a 3VDC/18mAh (Li-Al) alloy-Manganese Dioxide Coin Battery (ML 1220 - Rechargeable) of
diameter 12.5mm and height 2.0mm. The Battery should be replaced only by authorized dealers of Matrix. End
Users must not attempt to replace it.
There is risk of explosion if the Battery is replaced in an incorrect manner. Please dispose-off used
Batteries.
Disposal
This product must be disposed off according to the national laws and regulations prevailing in the country where it
is installed.
Getting Started
• Select an appropriate site to install the SETU VFXTH, considering the safety precautions listed earlier in
this chapter.
• Unpack SETU VFXTH and verify the package contents:
• SETU VFXTH Unit
• Power Adapter - 24VDC, 2.5A (Country Specific)
• Ethernet Cable (RJ45)
• Two Screws M7/30 with grips
• Wall Mounting Template
• Warranty Card Set
• Two 19 inch Rack Mounting Clamps
Make sure the package contains the above mentioned items. In case any of these is missing or damaged,
contact the dealer/distributor from whom you have purchased it.
• Place the system at the selected location.
To Next Page
Loading...
Need help?
General
