Matrix SETU VFXTH System Manual

241 Matrix SETU VFXTH System Manual
SNMP Settings
• Click SNMP Settings to expand.
• Select the Enable SNMP? check box. Default: Disabled.
• Configure the SNMP Listening Port. Valid Range:161, 1031-65535. Default: 161.
• Select the SNMP Version as supported by your SNMP Manager. You can select from:
•SNMPv1
•SNMPv2c
•SNMPv3
For enhanced security, you must select SNMPv3.
• Configure the System Name. When there are multiple devices connected in the same network, the
name configured helps to identify the SNMP Agent within the network. The System Name can be a
maximum of 40 characters. Default: Blank.
• Configure the System Contact. It is the name and number of the person to be contacted, in case of
notification. The System Contact can be of a maximum of 40 characters. Default: Blank.
• Configure the System Location. This is the physical location of SETU VFXTH. This information is
helpful to the administrator. The System Location may consist of a maximum of 40 characters. Default:
Blank.
• Select the Listen from Specific Manager check box, if you want the system to listen to the incoming
SNMP messages from a specific manager. Default: Disabled.
• If you have enabled Listen from Specific Manager check box, you must configure the specific
Manager’s Address.
The Manager’s Address can be a Domain Name or an IP Address. It can be a maximum of 64
characters. Default: Blank.
• If SNMP version is set as SNMPv1 or SNMPv2c, configure Community Name.

Matrix SETU VFXTH Specifications

General

Brand	Matrix
Model	SETU VFXTH
Category	Gateway
Language	English