Matrix Visionpro System Manual

127 Matrix VISIONPRO System Manual
How to configure
To assign the Call Progress Tone Region Code as per the country/region,
• Enter SE mode.
• To configure the CPTG Type, dial,
1109 - Region Code
Where,
Region Code is from 00 to 39.
Default code is 00.
Refer table below to assign the required Region Code (first column),
Feature Tone Short beep followed by
a longer OFF duration
repeated every second;
played when dialing
feature access codes
Beep.................
Beep
Played for 7 seconds.
Programming
Tone
Short beep followed by
a longer OFF duration
repeated every second
and exactly similar to
the Feature Tone;
played to prompt you to
enter fresh commands
during programming
Beep.................
Beep
Played for the duration
of the Inter Digit Timer
(default: 015 seconds)
which signifies the time
for which VISIONPRO
waits between
accepting two digits
from the SE/SA
programming mode.
This timer is loaded
when the SE/SA dials
the first digit and waits
for the second digit.
Inter Digit Timer
(this timer is
programmable)
Programming
Confirmation
Tone
Continuous, fast beeps;
played to indicate that
system has received a
valid command and is
processing it.
Beep... Beep...
Beep
Played for 3 seconds. Programming
Confirmation Tone
Timer (this timer is
programmable)
Programming
Error Tone
Fast beeps, played on a
wrong programming
command being dialed.
Too…Too…Too
…Too
Played for 3 seconds. Programming Error
Tone Timer (this
timer is
programmable)
CPTG
Region
Code
Region
Dial tone 1 Dial Tone 2 Ring Back Tone Busy Tone
Freq.
Cadence
(sec)
Freq.
Cadence
(sec)
Freq.
Cadence
(sec)
Freq.
Cadence
(sec)
00 Region1 440 Continuous 350+440 Continuous 350+440 0.4on 0.2off
0.4on 2.0off
440 0.75on 0.75off
01 Region2 400 Continuous 400 Continuous 400 0.6on 0.2off
0.2on 2.0off
400 0.5on 0.5off
CPT Event Sound Duration Timer

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English