Matrix Visionpro System Manual

Matrix VISIONPRO System Manual 28
Configuring using the Phone Wizard
VISIONPRO supports a special mode to quickly configure some of the basic features which can render the system
in an optimum working and usable condition without much rigorous programming. This mode of programming is
referred as the Phone Wizard.
Phone Wizard allows programming of certain basic features only. For detailed programming of all the
features, refer the respective feature description.
How it works
Like normal programming, you must enter the programming mode to start configuring the system. SE Programming
Access must be allowed in the “Class of Service (CoS)” of the station from which Phone Wizard configuration is to
be done.
• Phone Wizard programming mode can be entered from station 21 irrespective of the CoS assigned to
it.
• In general, wizard commands can be of 2 or 3 digits long. At any time you can exit the wizard by dialing
“0”.
How to configure
• To enter the Phone Wizard programming mode, dial,
1#98-SE Password.
Where,
Default SE Password is 1234.
The Phone Wizard consists of commands to configure the following parameters,
• “System Parameters”
• “Station Parameters”
• “Trunk Parameters”
System Parameters
Following System Parameters can be configured using the wizard,
• Set Current Date
• Set Current Time
• Set New SE Password
• Set New SA Password
Set Current Date
•Dial 27-Date-Month-Year-Day
Where,
Date is from 01 to 31
Month is from 01 to12

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English