167 Matrix VISIONPRO System Manual
Flexible Numbers
VISIONPRO offers flexibility to assign a number of your choice to a station. This number is called the Flexible
Number of the station. For example, to call the first station having software port number 00, one has to dial 21. It is
possible to change this code to any other number of your choice.
The system loads default access codes (flexible numbers) to all the stations on first power ON. Later on the stations
can be assigned desired flexible numbers, if required.
Flexible numbers can be dialed from dial phase to call another station. These numbers should be unique and
should not match with any other station or any of the feature commands available during the dial phase.
It is possible to have single digit, 2-digit, 3-digit and 4-digit flexible numbers. Few stations may have single digit, few
may have 2-digit, few may have 3-digit and remaining may have 4-digit flexible numbers.
• It is not possible to give any station, a flexible number ‘0’.
• If the flexible number of a station starts with a digit which is same as the feature access code for some
specific feature, then ‘*’ is required to be dialed before accessing that feature. For example, if a station
is assigned a flexible number 42 then to access the Group Call Pickup feature, the user must dial ‘*4’
(default feature access code for Group Call Pickup is ‘4’ which must be preceded by a ‘*’ in this case).
• Flexible number having common digits can’t be assigned to another station. For example, if 3101 is
used then 310 cannot be configured. Same way if 3111 is used then 311 cannot be configured.
• Same flexible number cannot be assigned to two different stations. For example, if you have used 211
for one station then 211 can’t be assigned to any other station.
• It is possible to clear the flexible numbers of all the stations. However, the default values can be
restored by executing the command to set the flexible numbers of all the stations to their default values.
• When the flexible number of a station is cleared, one cannot call that station. However the station can
make calls as usual.
• Use flexible numbers for all the features used from the User mode. Software port numbers are to be
used only during SE or SA mode.
How to configure
To configure the flexible numbers as per your requirement,
• Enter SE mode.
• To configure the flexible number for a station, dial,
4201-1-Station-Flexible Number-#*
Where,
Station is from 00 to 07.
Flexible Number can be any number string having 1, 2, 3 or 4 digits.
Terminate the command using ‘#*’ if flexible number is less than four digits.
To Next Page
Loading...
Need help?
General
