Matrix Visionpro System Manual

Matrix VISIONPRO System Manual 212
User Password
The User Password is a 4-digit code for station users to protect their station phones from unauthorized use. The
default User Password is 1111. It can be changed by the station users from their phones to any desired value, not
exceeding 4 digits.
In case the station user forgets the password, it can be cleared and restored to the default value 1111 by the
System Engineer (SE) or the System Administrator (SA).
The User Password is required to access and use the following features of VISIONPRO.
• Call Follow Me
• Dynamic Lock
• Direct Outward System Access (DOSA)
• Walk-In Class of Service
• The station user must change the default password for all the above listed features. The system will not
allow feature access with the default User Password.
• The User Password for a station can be changed only from that station phone. However it can be
cleared by SE from any other station, which has access to the programming mode.
How to use
To change the User Password,
• Lift the handset.
•Dial 144
• Dial the current User Password (default password 1111 if not changed already).
• Dial a new User Password (maximum 4 digits).
• You get Confirmation Tone.
• Replace handset.
To assign default User Password to a station
• Enter SE mode.
•Dial, 1106-Station
Where,
Station is from 00 to 07.
• Exit SE mode.

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English