165 Matrix VISIONPRO System Manual
Dynamic Lock
Dynamic Lock allows station users to change the Toll Control Levels (Calling Permissions) of their stations on their
own by dialing a code. With this feature, station users can prevent misuse of outgoing call facility from their stations,
specially in their absence.
Stations can be locked manually or automatically.
• If manual lock is selected, then user should lock the station while leaving the work place by dialing the
required command. On returning back to work place, the station can be unlocked by dialing another
command.
• If automatic lock is selected, the system locks the station after the programmed time duration automatically
on executing the lock command. The timer starts from the time when the station is locked and it can be
programmed.
• The changing of Toll Control requires the station user to dial the four-digit User Password. The system
will not accept the default User Password (1111). The station user must first change the default User
Password. Refer the topic “User Password” for instructions on changing the password.
• The Dynamic Lock Timer can be set to a maximum of 99 minutes.
• The Dynamic Lock Timer must be set to '00' when using Manual Dynamic Lock.
How it works
When a user locks his/her station, the toll control of the station changes to limited dialing or no dialing.
If you lock your station and thereafter dial out a number, VISIONPRO will compare the dialed number string with the
number strings in allowed and denied lists for the locked status. This is called Dynamic Toll Control. You must
assign the required allowed and/or denied number list to the station.
So before using Dynamic Lock,
• Make sure to configure the desired allowed and denied lists. If the default allowed and denied lists satisfy
your requirement, then you should not customize any of the lists. To configure either lists, refer “Allowed
and Denied Lists”.
• Assign the desired allowed and/or denied lists to the stations according to which numbers can be dialed
out when the stations are locked. To assign the allowed and/or denied lists as per Day or Night time, refer
“Toll Control”.
• Allowed list 0 and Denied list 0 are assigned in locked condition by default.
• Default allowed list for Day and Night is ‘2’ whereas default denied list for Day and Night is ‘4’.
How to configure
• For this feature to work, it must be enabled in the Class of Service of the stations. Refer “Class of Service
(CoS)” for details.
To Next Page
Loading...
Need help?
General
