Matrix Visionpro System Manual

Matrix VISIONPRO System Manual 162
For the remaining list of timers, refer “DID Timers” in “Direct Inward Dialing (DID)”.
As mentioned above, configure DOSA parameters as follows,
• Enter SE mode.
• To activate/deactivate DOSA on a trunk during Day time, dial,
3601-1-Trunk-Code
Where,
Trunk is the software port from 0 to 2.
• To activate/deactivate DOSA on all the trunks during Day time, dial,
3601-*-Code
• To activate/deactivate DOSA on a trunk during Night time, dial,
3602-1-Trunk-Code
Where,
Trunk is the software port from 0 to 2.
• To activate/deactivate DOSA on all the trunks during Night time, dial,
3602-*-Code
• Assign a CoS group having DOSA enabled to a station. For more details, please refer “Class of Service
(CoS)”.
• To configure the DOSA Inactivity Timer, dial,
3020-Seconds
Where,
Default: 060 seconds.
Valid Range: 000 to 255 seconds.
• To configure the DOSA Warn Timer, dial,
3021-Seconds
Where,
Default: 015 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
Example:
Consider the following requirements:
Station : 23 (software port 02), Trunk : 0, CoS group : 7 (DOSA enabled), CoS group : 4 (DOSA disabled).
You have to disable DOSA during Day time and enable DOSA during Night time.
Code Meaning
0 DOSA deactivated
1 DOSA activated
Code Meaning
0 DOSA deactivated
1 DOSA activated

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English