Matrix Visionpro

Matrix VISIONPRO System Manual 186
Use following command to configure LCR time zones:
3412-1-0-0800-1600
3412-1-1-1600-2000
3412-1-2-2000-2300
3412-1-3-2300-0800
Use following commands to assign service providers for the respective time zone:
3413-1-0-0-2-1-0
3413-1-1-2-0-1-3
3413-1-2-1-0-2-1
3413-1-3-0-1-2-0
With above programming the Time Zone based LCR table will look as below:
Example 2:
• Three trunks, one trunk of BSNL, one of Hughes and one of Reliance are connected to VISIONPRO.
• BSNL is cheapest for Baroda-Mumbai call followed by Reliance and Hughes.
• Reliance offers cheapest service if a local is made to 2665555 from 2630555 followed by Hughes and
BSNL.
• Hughes offers cheapest service for Baroda-Delhi call followed by BSNL and Reliance.
Service providers can be assigned SP numbers as -
BSNL = SP0.
Reliance = SP1.
Hughes = SP2.
Use following command to assign SP numbers to each trunk:
3402-1-1-0
3402-1-2-1
3402-1-3-1
Use following command to configure Number based LCR type:
3401-1-0-2
Use following command to configure number index for LCR:
3422-1-0-022-#*
3422-1-1-665555-#*
3422-1-2-011-#*
Use following command to assign SPs for respective numbers:
3423-1-0-0-1-2-0
3423-1-1-1-2-0-1
Time Zone Index
Service Providers in hierarchical order of
increasing cost
08:00 to 16:00 0 3 2 0
16:00 to 20:00 3 0 2 3
20:00 to 23:00 2 0 3 2
23:00 to 08:00 0 2 3 0