Matrix Visionpro System Manual

227 Matrix VISIONPRO System Manual
Configure the same Disconnect Supervision type for all
trunks
3115-*-Code
Configure the Open Loop Disconnect Timer for a trunk 3116-1-Trunk-Code
Configure the same Open Loop Disconnect Timer for all
trunks
3116-*-Code
Configure the Pseudo Answer Supervision Timer for a
trunk
3117-1-Trunk-Seconds
Configure the same Pseudo Answer Supervision Timer
for all trunks
3117-*-Seconds
Enable/disable Call Disconnect Tone for a trunk 3133-1-Trunk-Code
Enable/disable Call Disconnect Tone for all the trunks 3133-*-Code
Set the Call Disconnect Tone Frequency for a trunk 3134-1-Trunk - Frequency 1 - Operator - Frequency 2
Set the Call Disconnect Tone Frequency for all trunks 3134-*-Frequency 1 - Operator - Frequency 2
Set the Call Disconnect Tone Cadence for a trunk 3135-1-Trunk- Index - ON Time - OFF Time
Set the Call Disconnect Tone Cadence for all the trunks 3135-*- Index - ON Time - OFF Time
Configure the Ring Cadence OFF Timer for a trunk 3118-1-Trunk-Code
Configure the same Ring Cadence OFF Timer for all
trunks
3118-*-Code
Configure the DTMF Detection Minimum ON Timer for a
trunk
3119-1-Trunk-Code
Configure the same DTMF Detection Minimum ON
Timer for all trunks
3119-*-Code
Configure the DTMF Detection Minimum OFF Timer for
a trunk
3120-1-Trunk-Code
Configure the same DTMF Detection Minimum OFF
Timer for all trunks
3120-*-Code
Configure the DTMF Outdial ON Time for a trunk 3121-1-Trunk-Code
Configure the same DTMF Outdial ON Time for all
trunks
3121-*-Code
Configure the DTMF Outdial Inter-digit Pause Time for a
trunk1
3122-1-Trunk-Code
Configure the same DTMF Outdial Inter-digit Pause
Time for all trunks
3122-*-Code
Configure the Flash Timer for a trunk 3123-1-Trunk-Code
Configure the same Flash Timer for all trunks 3123-*-Code
Configure the ON-Hook Speed for a trunk 3126-1-Trunk-Code
Configure the same ON-Hook Speed for all trunks 3126-*-Code
Configure the OFF-Hook Speed for a trunk 3127-1-Trunk-Code
Configure the same OFF-Hook Speed for all trunks 3127-*-Code
Configure the Current Limiting Mode for a trunk 3128-1-Trunk-Flag
Configure the same Current Limiting Mode for all trunks 3128-*-Flag
Configure the Minimum Loop Current for a trunk 3129-1-Trunk-Code
Configure the same Minimum Loop Current for all trunks 3129-*-Code
Configure the TIP-RING Voltage for a trunk 3130-1-Trunk-Code
Configure the same TIP-RING Voltage for all trunks 3130-*-Code
Configure the Ringer Impedance for a trunk 3131-1-Trunk-Code
Configure the same Ringer Impedance for all trunks 3131-*-Code
Configure the Ringer Threshold for a trunk 3132-1-Trunk-Code

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English