Matrix Visionpro System Manual

25 Matrix VISIONPRO System Manual
How these three configuration modes are related to each other, has been shown in the figure below.
System Engineer (SE) Mode
At the System Engineer level, the entire system configuration, all programmable features and facilities of the
VISIONPRO can be changed as per the end user requirements. All the programming commands are allowed from
SE mode.
Only the System Engineer, the person who installs, configures and maintains the PBX must be allowed access to
this mode.
Access to the SE mode is protected by means of a password, referred throughout this document as the SE
Password. SE Password is a 4-digit secret code used to avoid unauthorized access to SE mode. By default, SE
Password is 1234.
If you forget the SE Password, you can restore it to its default value. Refer “System Security (SE and SA
Passwords)” for instructions.
Entering the SE mode using a Telephone
• You can enter the SE mode only from the stations which have 'SE Programming Access' allowed in
their “Class of Service (CoS)”. By default, station 21 is given access to the programming mode.
• Only one person can enter the SE mode at a time.
To enter the SE mode from a station of VISIONPRO,
•Dial 1#91-SE Password.
• You get Programming Tone to indicate entry into the SE mode.
• Now, dial the desired SE command to configure. For the list of commands, refer “Programming
Commands”.
• You get the Confirmation Tone.
To exit the SE mode,
•Dial 00.
• You will hear the Dial Tone of the VISIONPRO.
Programming the VISION
SE Level
User Level
SA Level

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English