91 Matrix VISIONPRO System Manual
Remote Alarm
A Remote alarm can be set by any station user/operator for some other station. At the set time, the remote station
(on which the alarm has been set) starts ringing with a different ring cadence. When the station user lifts the
handset, music/voice message is played.
• You can set a single Time alarm or a Duration alarm or a Daily alarm on one remote station at a time.
However, different types of these alarms (that is, Time alarm or Duration alarm or Daily alarm) can be
set simultaneously on the same remote station.
• Any station can set Remote alarms on other stations only if ‘Remote Alarm’ feature is allowed in its
Class of Service. However, if the remote station has the Alarm feature disabled in its CoS and the
operator sets Remote Alarm for that station, alarm is set and played successfully.
How to configure
Alarm and Remote Alarm, both are configurable features. To allow access to set/cancel Alarm and Remote Alarm
to a user refer “Class of Service (CoS)”.
Alarm Ring Timer
This is the duration for which a station rings when it receives an Alarm call.
To configure the timer,
• Enter SE mode.
•Dial 3013-Seconds
Where,
Allowable range for seconds is 000 to 255.
Default: 045 seconds.
• Exit SE mode.
Voice Message for Alarm
You can configure the system to play the desired voice message when users answer the alarm call. For more
details, refer “Voice Message Applications”.
How to use
Alarms can be set/canceled by the station users themselves. The station users can also ask the Operator to set
Remote alarms for them, if required.
Setting a Duration Alarm
• Lift the handset.
•Dial 161
• Enter the Minutes. Minutes is from 00 to 99.
• Replace handset.
To Next Page
Loading...
Need help?
General
