Matrox Extio 3 Series – User Guide 33
Validating network discovery
Extio 3 devices are initially assigned their IP addresses through DHCP (Dynamic Host Control
Protocol). After connecting your devices, we recommend verifying that all of your devices are
discovered by the network.
Windows 10/7
– To make sure all of your devices are discovered by the network:
Windows 10
– Click
Start
Æ
File Explorer
Æ
Network
. Under
Other Devices
, make sure
all the Extio 3 devices connected are listed.
Windows 7
– Click
Start
Æ
Acessories
Æ
Windows Explorer
Æ
Network
. Under
Other
Devices
, make sure all the Extio 3 devices connected are listed.
If prompted to enable network discovery and file sharing on your network when validating network
discovery, enable these two features by clicking on the prompt at the top of your Windows Explorer
window. These two features must be enabled for Extio Central Manager software to detect the Extio 3
devices.
Installing Matrox Extio Central Manager software
Matrox Extio Central Manager software enables you to remotely manage, monitor,
and configure your
networked
Extio 3 devices.
Supported operating systems
Matrox Extio Central Manager supports the following operating systems:
Windows® Server® 2016
,
Windows® 10 (64-bit)
,
Windows® Server 2012 R2
,
Windows® Server® 2008 R2
, and
Windows® 7
.
Obtaining Matrox Extio Central Manager software
To obtain the latest Extio Central Manager software, contact your Matrox representative. Matrox
makes the latest Extio Central Manager software available on the Matrox web site
(www.matrox.com/graphics/extio3sw
).
Installing Matrox Extio Central Manager software
To install the software for your Extio 3 product, run the installation program for your software
package on any system on the network. Follow the on-screen instructions.
Note:
Only one (1) instance of Extio Central Manager software needs to be installed.
To Next Page
Loading...
