Matrox Extio N3408 - Updating Firmware (Networked Mode); Download and Extract Package; Run Network Updater; Scan for Devices

Matrox Extio 3 Series – User Guide 29
Updating your Matrox Extio 3 firmware (networked mode)
1 Download and extract the firmware package
Download the latest firmware package and extract the files to a local folder on your system
(for example,
C:\Extio3FirmwareUpdate ). If you don’t select a local folder, the files will
automatically extract to
C:\Matrox .
2 Run the Updater Over Network file
Browse to the folder containing the extracted files, then run the UpdaterOverNetwork.exe file.
3 Scan for available Extio 3 devices or locate your Extio 3 device
using the IP address
Automatic detection – To scan for Extio 3
devices on your subnet, select
Automatic
detection
, then click Search .
Manual detection – To locate one or more
Extio devices using their IP address, select
Manual detection , and next to IPv4
addresses
enter the IP address of each Extio
device you want to locate. If you’re entering
multiple addresses, separate each address
with a space. (You can also enter the IP
addresses by clicking the browse button
( ) and entering one IP address per line.)
When you’re done entering the IP addresses,
click
Apply .
To stop searching for devices, click Stop . To resume
searching for devices, click
Search again.
Note: If you’re using networked mode, make sure the version of your firmware package
matches the version of the Matrox Extio Central Manager software package installed on
your controller system.