Matrox Extio N3408 - Changing Operation Mode; Procedure for Mode Change

Matrox Extio 3 Series – User Guide 43
Changing the operation mode of your
devices
If you change the operation mode of your Extio 3 configuration (for example, changing from
networked mode to point-to-point mode, or vice versa), you need to do the following:
1 Disconnect the network cables from your Matrox transmitter device and receiver device
(see “Connecting your Extio 3 devices”).
2 Perform a configuration reset on your transmitter device and receiver device (see
“Hardware reboot or configuration reset”, page 42).
3 Change the connection setup of your devices (see “Connecting your Extio 3 devices”,
page 14).
4 Reboot both your Matrox transmitter device and receiver devices (see “Rebooting or
resetting your Extio 3 device”, page 41).
5 Configure your Extio 3 devices again:
 Networked mode – use Extio Central Manager software to configure your devices.
For more information, see your Matrox Extio Central Manager user guide.
 Point-to-Point mode – use the OSD to configure your devices (see “Setting up
point-to-point mode”, page 37).