Matrox Extio 3 Series – User Guide 37
Setting up point-to-point mode
Matrox Extio 3 transmitters and receivers can be configured as a point-to-point extender. In point-
to-point mode, Extio 3 transmitter and receiver devices are directly linked to each other using copper
or fiber optic cable.
Before you begin
Whenever you change your connection setup, make sure you’re using the correct
connectors and that all connectors are properly fastened. Also, don’t change connections
while your Extio transmitter and receiver are turned on. For more information, see
“Connecting your Extio 3 devices”, page 14.
Make sure all of your Extio 3 transmitter and receiver devices are using the latest version
of the Matrox Extio 3 firmware package.
To enable point-to-point mode, make sure your transmitter deivce and receiver device
are directly (physically) connected to each other. For more information, For more
information, see “Connecting your Extio 3 devices”, page 14.
For information on supported cable types and distances, see “Maximum distance
(point-to-point mode)”, page 49.
Review the safety information provided. For more information, see “Matrox safety
information”, page 5.
To Next Page
Loading...
