Matrox Extio 3 Series – User Guide 35
Accessing the OSD
The OSD is available only with Extio 3 receiver devices. To access the OSD, enter the OSD keyboard
shortcut on the keyboard connected to your receiver. The default keyboard shortcut is the [Scroll
Lock] key.
Changing the OSD keyboard shortcut
You can change the keyboard shortcut used to access the OSD.
Change the keyboard shortcut through Extio Central Manager. For more information, see your
Matrox Extio Central Manager User Guide.
Enabling networked operation mode
To use networked mode, you need a user name and password. To obtain a user name and device
password (or if you’ve forgotten your user name or device password), contact your Extio environment
administrator.
Basic functions
Switching to a different transmitter
1
Under
Transmitters
, select the transmitter you want to switch to.
2
Click
OK
.
Note:
To access the OSD and enable networked mode, make sure you obtain a user name
and password from your Extio 3 environment administrator. For more information,
contact your network administrator.
Note:
To change the operation mode of your Extio 3 configuration (for example, changing
from networked mode to point-to-point mode), you need to perform a configuration reset
of your devices. For more information, see “Changing the operation mode of your devices”,
page 43.
OK Click
OK
for your changes to take effect.
Cancel Click
Cancel
to discard any changes that weren’t applied.
Logout Click this to log out of the device.
Wake-on-LAN
Click
Wake-on-LAN
to wake up your transmitter if it turns off.
This has no effect if a transmitter isn’t detected.
To Next Page
Loading...
