Page 91 P/N 03521015 Rev Q
Don HLF (NOT optional - Required per NIOSH Approval)
3. Ensure Hood Skirt is fully down on all sides,
secure neck ties to within about 1/2 inch of
neck, and feed body ties through front hood
shroud slits and tie securely.
1. Initiate donning the HLF (Heavy Load-
ing Filter) by tucking its back bottom
up under back bottom of Helmet
2. Complete by pulling HLF over and down,
rear-to-front, of the Helmet and securing
front bottom on Hood front Velcro strip.
2. Either continue grasping the HLF and lift it up, over, and o the
Helmet and discard appropriately,
or, ALTERNATIVELY,
you may temporarily leave it on the Hood and proceed to Do it
with the Hood (next section).
1. Hold front of HFR FCC in
place while lifting its rear up
over Helmet.
1. Begin HLF dong by curling its back bottom up over Helmet
back bottom.
Don HFR FCC (Optional, depending upon uid resistance protection desired.)
3. As needed, pull down back of HFR FCC with ngers in
back while pushing up on under side of Helmet back with
thumb.
1. Initiate donning the HFR FCC (High
Fluid Resistant Filter Cover Cap) by
placing it over the front of the Helmet
and down towards the back.
2. Continue bringing the HFR
FCC down over the Helmet
so that it covers the HLF.
Do HFR FCC (If it was Donned)
2. Remove HFR FCC completely
and decon for next use.
Do HLF
To Next Page
Loading...
