Page 96 P/N 03521015 Rev Q
Do the Hood, Helmet, and Battery and Belt
1. Untie both neck
and body Ties.
13. Connect a powered on Battery Charger connector
to the Battery. Push connector into Battery recep-
tacle fully - Do NOT push down on the Battery
Secure Lock (Black) button.
3. Re-tie both neck and body
Ties in front, out at their
most distant extremities.
4. Pull the Hood body, just
below the Filter, back and up
to lift the back of the Filter up
over the back of the Helmet.
5. Use the body ties to pull the Hood, Filter
and both Shrouds, up and over the top of
the Helmet. The HLF, if left on, will come
o the Helmet in this and next steps.
7. Continue the rolling process while
moving the entire Hood (and HLF)
over, o, and forward from the
Helmet.
6. As the back Hood body bottom comes up
over the Helmet, roll the Hood (and HLF)
and ties over themselves to compact them
and minimize self contamination.
8. Continue the rolling process until the
Hood is at the front of the Helmet, then
lift upwards slightly to lift the front Hood
Lens mounting hole up and o the front
Helmet mounting post.
9. When the Hood (and HLF) is com-
pletely o the Helmet and out in front
of you, discard it appropriately as with
other disposables per your institutional
hazardous waste protocol.
10. Turn Helmet Ratchet Knob
counterclockwise to loosen
Headband and lift Helmet up,
over, and o the Head, and prep
the Helmet for next use.
12. Disconnect the Helmet Power Cord from the
Battery - Press down on the Secure Lock (Black)
Button to release, then pull the cord connector out
from the Battery connection receptacle.
2. Lift up Hood outer Shroud and
open outer body gown sucient
to allow Hood inner Shroud to
be pulled up and o. (HLF may
be on, or o per previous Do
HLF step.)
11. Unbuckle Belt and
remove Battery and Belt
from around the waste.
To Next Page
Loading...
