Page 95 P/N 03521015 Rev Q
Don HLF (NOT optional - Required per NIOSH Approval)
3. Ensure Hood outer Shroud is
fully down on all sides, secure
neck ties to within about 1/2
inch of neck, and feed body
ties through front Hood Shroud
slits and tie securely.
1. Initiate donning the HLF
(Heavy Loading Filter) by
tucking its back bottom up
under back bottom of Helmet
2. Complete by pulling HLF over
and down, rear-to-front, of the
Helmet and securing front bot-
tom on Hood front Velcro strip.
Don HFR FCC (Optional, depending upon uid resistance protection desired.)
3. As needed, pull down back of HFR FCC with ngers in
back while pushing up on under side of Helmet back with
thumb.
1. Initiate donning the HFR FCC (High
Fluid Resistant Filter Cover Cap) by
placing it over the front of the Helmet
and down towards the back.
2. Continue bringing the HFR
FCC down over the Helmet
so that it covers the HLF.
17. Tuck Hood inner Shroud
under the outer body
gown and secure the
gown closure. Pull Hood
outer Shroud over the
shoulders and body.
2. Either continue grasping the HLF and lift it up, over, and o the
Helmet and discard appropriately, or,
ALTERNATIVELY,
you may temporarily leave it on the Hood and proceed to Do it
with the Hood (next section).
1. Hold HFR FCC front and lift
its rear up over Helmet.
1. Begin HLF dong by curling its back bottom up over Helmet
back bottom.
Do HFR FCC (If it was Donned)
2. Remove HFR FCC com-
pletely and decon for next
use.
Do HLF
To Next Page
