11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
33
TRUCK CHASSIS CUTOUT
(LH SIDE SHOWN)
FIG. 33-1
TRUCK FLOOR
CHASSIS
CUTOUT
11”
3. If required, mark position for chassis cutout
on both sides of the truck chassis (FIG. 33-1).
Refer to TABLE 29-1 for dimension CH. Cut
chassis to dimensions shown.
REAR SILL
CH
NOTE: If truck chassis interferes with Liftgate installation, cut the chassis as shown
below. Refer to TABLE 29-1 for CH dimension.
STEP 1 - INSTALLING LIFTGATE ON TRUCKS - Cont’d
To Next Page
Loading...
