McHale Orbital Round Bale Wrapper
32
5.3 Attaching to drawbar
The drawbar is to be attached so that the machine is horizontal to the ground.
Machines are set up for hitching to the tractor drawbar. Once the tractor is attached to
the drawbar, attach the PTO shaft. Depending on the country of use a safety chain may
also be required. Detach in reverse order of attachment.
CAUTION: Do not connect control box to a 24 V power supply
Do not attempt to connect the control box to a power supply greater
than 12 V, as machine component damage will result.
CAUTION: Tractor drawbar and coupling device must be compatible
Check that the tractor drawbar is compatible with the coupling device
on the machine. If in doubt, consult your McHale dealer.
To Next Page
Loading...
