McHale Orbital - Wrapping process

McHale Orbital Round Bale Wrapper
64
Out of film
8.4 Wrapping process
The wrapping process starts automatically as soon as the bale has been transferred
from the load arm to the wrapping table. After the bale is wrapped with the selected
number of film layers, two ‘Cut and Hold’ units grip and cut the film. The wrapping cycle
is completed and the bale is ready for discharging.
Dispenser position error symbol
l
NOTE: Bale will not transfer if dispenser ring is in wrong position
The bale will not transfer from the load arm if the dispenser ring is in the
wrong position. This is a safety feature and is normal. In this case an
audible alarm will sound and the ‘Dispenser Position’ error symbol will be
displayed in the control box display. The forward and reverse soft key
indicators will become active on the control box. Press the appropriate
button in order to correct the position of the dispensers and then press
the AUTO LOAD button to load the next bale.
CAUTION: Do not tip off bales while moving
The machine should not be moving when the bale is tipped off, as this
greatly increases the risk of plastic film damage.