McHale Orbital Round Bale Wrapper
63
9. Pull approx. 1.5 m of film away from
the dispenser and make a knot at the
end, as before.
10. Insert the knotted end of the film into
the left hand side slot of the rear
wrapping roller.
11. Grab hold of the dangling film on the
right hand dispenser and insert the
knotted end of the film in the right
hand side slot of the rear wrapping
roller.
12. Close the door firmly making sure
that both primary and secondary
latches have been engaged.
WARNING: Do not clamp film in the ‘Cut and Hold’ mechanism
Do not attempt to clamp plastic film in the ‘Cut and Hold’ mechanism as
this action may result in serious injury!
NOTE: Resume a cycle interrupted by ‘Out of film’ error symbol
Press and hold the AUTO START button on the control box to resume
and complete the wrapping cycle of a bale that is interrupted by an ‘Out
of film’ error symbol, as shown below.
To Next Page
Loading...
