McHale Orbital Round Bale Wrapper
71
Ensure that the tyres are set to the correct pressure as per safety decals and
according to the specifications. (See ‘Tyre specifications’)
Ensure that all doors are securely closed and fastened, ensuring that primary
and secondary catches are fully engaged, these should be kept clear of
foreign objects to ensure proper and trouble free operation.
The lighting system of the machine must be connected to the tractor and must
be in a fully functioning condition; ensure that the work lamp is switched off.
The hydraulic supply must be turned off and protected from accidental activation
by disconnecting the hydraulic feed line. Support all loose lines in a safe manner.
The electronic control box must be switched off or disconnected from the
power supply. (See ‘Electronic control box functions’)
Ensure the oil supply is turned off and cannot be turned on accidentally.
Attention must be paid to the maximum travel speed limit (40 km/h).
If plastic film is to be transported on the machine it must only be done so on
the holders provided and secured if necessary.
Ensure that all the national road traffic regulations relating to the country are
fulfilled i.e. the use of safety chains is mandatory in EU countries when air
brakes are not installed. The safety chain must be attached in such a way that
if the coupling breaks, the hitch or drawbar cannot make contact with the
ground.
9.2 Road transportation with side-tip attached
Side-tip must be folded vertically and secured.
Ensure the transport-pin is secured in the transport position with the linch-pin
attached. (See ‘Side-tip’)
Do not attempt to go over 20 km/h at any time, while the side-tip attachment is
in the field working position.
By inverting the hitch eye assembly further adjustment positions can be
achieved.
CAUTION: Side-tip must not be used on public roadways!
Side-tip must not be used on public roadways and must always be folded
vertically beforehand.
To Next Page
Loading...
