PRE-DELIVERY INSPECTION (PDI)
Dealer:.............................................................. Model: Orbital
Full address:...................................................... Serial No:..........................................................
.......................................................................... Date Delivered:.................................................
Fitter:................................................................. Date Inspected:.................................................
Customer:........................................................
Full Address:..................................................... Tel:.....................................................................
.......................................................................... Mobile:...............................................................
.......................................................................... E-mail:...............................................................
ENSURE THAT THE TRACTOR IS OF THE CORRECT SPECIFICATION FOR THIS MACHINE.
REFER TO THE OPERATOR INSTRUCTOR MANUAL BEFORE MAKING ANY ADJUSTMENTS!
This machine must be registered on www.mchale.net by the Dealer in order to qualify for Warranty!
1.
Check that all accessories are with the
Owner/Operator. Check Operators
Instruction Manual and Parts Lists.
10.
Adjust drawbar-swing/safety
transportation-bar.
2.
Ensure machine is re-assembled
correctly. (Refer to all assembly
instructions supplied)
11.
Check for smooth operation of all
moving parts. Check dispenser ring &
dispensers are running smoothly & free
from damage or grit.
3.
Ensure that the wheels are correctly
fitted (i.e. valve to the outside). Torque
wheel nuts correctly.
12.
Ensure plastic is applied to the centre of
the bale.
4.
Check for correct tyre type, tread and
pressure. (Tyre inflation pressure is
1.45 bar (21 psi))
13.
Check dispenser(s) are running
smoothly & free from damage or grit.
5.
Hitch machine to tractor/baler. Set
transportation bar and ensure all pins
are secure.
14.
Run the 'Auto' cycle on the control unit.
6.
Adjust drawbar to ensure wrapper is
parallel to the ground when coupled to
tractor/baler. Attach 7-pin plug for
lighting system.
15.
Check that all electrics and lights
function correctly.
7.
Connect hydraulic hosing to tractor
ensuring proper hydraulic setup.
Note: Ensure free-flow return to tank.
16.
The operator must be fully aware of all
hazards, controls (electric & hydraulic),
all functions & safety devices of both
the machine and the tractor.
8.
Ensure control-unit power supply is
12 V direct from battery otherwise the
machine may malfunction.
17.
Ensure that the owner/operator reads
the operator instruction manual and
understands fully all safety & operating
aspects of the machine, as described.
9.
Ensure the control-unit is on the correct
program. Check all manual functions
from the control unit.
18.
Instruct operator on machine
maintenance i.e. Check chain tensions,
adjustments, tyre pressure & wheel
nuts, also areas to be greased daily
along with all other routine functions.
I am satisfied that the above checks have been carried out, and that the machine is complete with all
accessories and manuals.
Signed:................................................................................... (Dealer) Date:..............................
Signed:................................................................................... (Owner) Date:..............................
A signed copy of this form is to be retained by both the Dealer and the Customer!
To Next Page
Loading...
